These Ice Banks are preassembled units consisting of:
– Tank with thermostatic expansion valve for the feeding of evaporators.
– Air Condensing Unit including control panel and connections.

Construction:
Inner Tank: galvanised iron-sheet.
Insulation: high density polystyrene with vapour barrier.
Outer Shell: painted galvanised iron-sheet.
Bottom: galvanised iron-sheet.
Upper Frame and Hooks: stainless steel.
Agitation: Air blower.
Evaporators: galvanised carbon-steel mode banks.
Feeding: evaporators equipped with distributors for liquid injection regulation.
Ice Control: for the condensing unit drive.

Advantages:
– In comparison with the systems planned to work without any stored refrigeration, less is the time of use more is the advantage. The relevant advantages are the following:
– Minimum capital cost because of the reduction of plant capacity
– Minimum running cost because of the possibility to avoid the top consumption’s and relevant penalties.
– Maximum safety since icing does not cause any breakage and damage like in the shell and tube chillers.
– Maximum dependability because of the possibility of using the ice until the service arrival.

Technical Characteristics:
Power Supply: 400V 3 phases – 50 Hz

Tank width = 2.300 mm

(*): C = With air condensing unit and refrigerating unit compact to the tank (on the width side); R = With remote air condensing unit and refrigerating unit compact to the tank

The Company reserves the right to modify the technical data and characteristics at any time without notice